 |
All PARTNER & ACS Phone System |
|
|
Program System Time (#103)
This System Programming procedure sets the time that appears on system display phones.
Enter the time in 24-hour notation. In this scheme, the hours of the day are 0000 (12 midnight) to 2359 (11:59 p.m.). Since each time must have four digits, use leading zeros when necessary. For example, to set the time to 9:00 a.m., enter 0900. For 4:45 p.m., enter 1645.
The time appears on system display phones as a.m. or p.m. (not in 24-hour notation).
To change the System Time using a display phone at extension 10 or 11:
- Press [Feature] [0] [0].
- Press [System Program] (Left Intercom button).
- Press [System Program] (Left Intercom button).
- Press [#] [1] [0] [3].
- Enter the time in 24-hour notation. For example, to set the time to 2:15p.m., press 1415.
A display similar to the following appears:
Note: The time will appear on system display phones as 2:15p.
- Select another procedure or press [Feature] [0] [0] to exit programming mode.
If you encounter problems programming this feature:
- You are not programming from extension 10 or 11? To determine the extension you are using, press [Feature] [0] [0]. The display should show "Programming ext. XX".
- You are not using a display phone.
- The Partner phone you are using is on a MERLIN Legend (R7) or MERLIN MAGIX system.? How can you determine if this is the case?? Pick up the handset and select a line button.? Dial [Feature] [#] [1].? If you hear a series of beeps, you are on a Partner system.? If you hear a waive-off (siren) tone, you are on a Legend or MAGIX system.
|
|
Program System Date (#101)
To program the system date on a Basic Partner Release 4.1
This System Programming procedure sets the month, day, and year. The system displays only the month and day on display phones when the phone is idle. The month, day and year print on Station Message Detail Recording (SMDR) call reports.
To change the System Date using a display phone at extension 10 or 11:
- Press Feature 00.
- Press System Program (Left Intercom button).
- Press System Program (Left Intercom button).
- Press # 101.
- Enter today's date in the form mmddyy, where mm = the two-digit month, dd = the two-digit day and yy = the last two-digits of the year. For example, to enter April 26, 2002, press 04 26 02.
After you enter the new information, a display similar to the following appears:
- Select another procedure or press Feature 00 to exit programming mode.
|
|
|